Select Create New Grid Only.

Select the data to grid: 

Select the Seismic Lines and Horizons.  Each selected horizon from every selected seismic line will be used in the gridding process.

Select the Well Tops and Sources.  This page will appear if Mixed or Batch Well Tops was selected.  The tops used in the gridding operation will be filtered based on the source selection.

Select the XYZ Columnar ASCII file.  This page will appear if Mixed or Single XYZ File was selected.  The data stored in the ASCII file will be used in the gridding process.

Select the Gridding Technique.  This is the algorithm that will be used to grid the data.

Select the Restricting Polygons to use.  This will allow you to specify the polygon to clip the data to.  Move the polygon under 'Inclusion' for areas to use to grid and 'Exclusion' for areas to omit.

Select the Grid Extents.  Either select an existing grid to match, specify the bin size or the number of bins to use.

(Optional) If a gridding technique that supports anisotropy was selected (such as kriging or minimum curvature), set the Anisotropy and Search Options.

Select the Grid Residuals.  Create and attach a surface trend and/or a residual.

(Optional) Save the Parameters.  Save the parameters used for the operation so that the grid can be replicated at a later date.